Fitting Instructions

Everything you need to fit your WoodlandByKat handles perfectly. Watch the video guide below or follow the written steps.

What's included

1 × handmade wooden handle
Fixing screws (M4 × 32mm as standard). If you need longer screws for thicker panels, just let us know in the special request field when ordering

If you need a different screw size or hole spacing, use the Special request field on the product page when ordering.

1
Mark your hole positions
Hold the handle against the door front where you'd like it positioned. Mark through the pre-drilled fixing holes with a pencil. Double-check alignment with a tape measure before drilling.
2
Drill pilot holes
Drill through the panel at your marked positions using a 6mm drill bit. Apply masking tape over the drill point to avoid chipping on delicate finishes.
3
Attach the handle
Insert the included screws through the back of the panel and into the handle's fixing holes. Tighten by hand first, then use a screwdriver to secure firmly. Do not overtighten, as this can crack the wood.
4
Check and enjoy
Give the handle a firm pull to confirm it's secure. Check again after the first few weeks of use and re-tighten if needed.

For thinner panels (<16mm), use shorter screws to avoid the tip protruding through the front.
Natural wood variations in grain and colour are not defects. Each handle is unique.
After fitting, wipe any pencil marks away with a slightly damp cloth.

Have a question or need help with your installation?